40 Amp 13.8V HAM Radio Power Supply 10-15.5 Volts Just Added to MegaWatt Line
(10-15.5 adjustable voltage) 40 amp Continuous Ham Radio Power Supply. Grounded, switched three prong power cord included. Adjustable from 10 to 15.5 volts. Fully regulated, 50 mV p-p ripple. Automatic RPM control of cooling fan through thermostat. Operates on 120 or 240 volts ac. Highly filtered for no RF noise.
Will operate any 12 volt electronic device. Run two, three or more in parallel to multiply the output amperage 80 Amps, 120 Amps, 160 Amps and more.
Run Two in Series for 24 Volt Output. Operates on 120 or 240 volts AC.
The size of the unit is 9 X 4 5/8 X 2 inches. This is not your typical inexpensive power supply.
Poorly or unregulated power supplies will cause your sound or radio equipment to hum while in use. This is a high quality commercial / industrial grade voltage regulated unit. Awesome for powering your high-powered car stereo or CB radio equipment in the house.
This unit has a built in cooling fan on a thermostat to control fan speed and over voltage/short circuit protection. It operates on 120 volts AC or 240 volts AC, 47Hz to 63Hz. It's fully shielded for use in a computer or radio environment. It is a nice small package, 9 X 4 5/8 X 2 inches. Is a "switching" power supply, which uses solid state electronics to produce the output voltage. This makes this unit much lighter, smaller and less likely to malfunction than the old fashion transformer type power supply. A 110 volt power cord is included with each unit.
