ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ    ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ

This amp did not work correctly with the original Chinese tubes. The bias was wrong from new. It Has been corrected with a matched set of Eimac 4cx250b and has worked well for years as a backup Amp.

There is a service addendum that I had to get from factory to correct the issue. It is included with the owners manual. It is wired for 120 vac and comes with original power cord. A Frequency Coverage: All amateur bands in the I. 8-29.7MHz frequency range; extensions and/or changes on request.

B Power Output: 700 W PEP or 500 W continuous carrier. C Intermodulation Distortion: Better than 35 dB below rated output.

D Hum and noise: Better than 40 dB below rated output. E Harmonic Output Suppression: Better than 50 dB below rated output. F Input and Output Impedance.

Nominal value: 50 Ohm unbalanced, UHF (SO-239) type connectors. Input circuit: broadband, VSWR less than 1.2:1, 1.8-30 MHz continuously (no tuning, no switching). Bypass path: VSWR less than 1. 1: I, 1.8-30 MHz continuously, 200 W maximum; - Output (antenna) impedance matching capability: VSWR up to 3:1 or higher.
G RF Gain: I I dB typically, frequency response less than I dB (50 to 70 W drive power for rated output). H Primary Power: 85-132 V/170-264 V ac (100, 110, 120, 200, 210, 220, 230 & 240 V nominal taps), + 10% - 15% tol. , 50-60 Hz, single phase, 1200 VA. I Complies with CE safety and electromagnetic compatibility requirements as well as FCC-regulations (10 & 12 m band locks provided).
J Operating size & weight, incl. Knobs and connectors see also S. 2-3 Amplifier Location Selection: WxDxH: 407x3 I 5x I 69mm, 18kg (I 6x I 2.4x6.65 inches, 39.7Lbs). Height: up to 3000 m above sea level without output deterioration. The item "ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ" is in sale since Wednesday, April 29, 2020. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers". The seller is "chnoll6" and is located in Lebanon, Pennsylvania. This item can be shipped to United States, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Bangladesh, Brunei darussalam, Bolivia, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Luxembourg, Monaco, Macao, Martinique, Nicaragua, Pakistan, Paraguay, Uruguay.
  • Model: ACOM 1011
  • Band: HF
  • Supported Modes: CW
  • Number of Outputs: 2
  • Color: Beige
  • Number of Inputs: 1
  • Brand: ACOM 1011

ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ    ACOM 1101 HF LINEAR AMPLIFIER 1.8 to 30 MHZ