HF power amplifier KIT MOSFET VRF2933 LPF 300W 1.8-30MHz with control and LCD
PA10-300W power amplifier 10W in, 300W out 1.8-30 MHz with LPF. This device is designed for use with SDR radios , like ANAN-10, FLEX-1500 or others. With 6 to 8 W input power from SDR it runs solid 300W to your antenna. The amplifier's output is filtered by LPF with diplexer, so the second and higher harmonics of transmitted signal are suppressed for more than -47 dBc.
To switch the filters you need simple open-collector circuit of SDR or external switch. This amplifier may be used with QRP transceivers like FT-817 or IC-703 (with automatic band decoder) also.
Active elements are matched pair of VRF2933 MOSFET transistors (see schematic) in AB-class. 2-tone measured IMD 3 is -40 dBc. Measured by KC901H network analyser suppression of second and third harmonics (amplifier with diplexer) is: 10 meters 2nd -52 dB 3rd -55 dB 20 meters 2nd -54 dB 3rd -47 dB 80 meters 2nd -53 dB 3rd -51 dB. The power supply requirements is 50V 10 - 12A. Board size 190 x 165 mm.
This controller is intended to control the EB300 300W HF power amplifier and protect it from. If any protection circuit works, it switches off the output transistors VRF2933 BIAS voltage first, reducing output power to zero and turns amplifier into RX mode.
Then driver output disconnects from PA input and connects to antenna. Controllers input has -4 dB attenuator and voltage suppressor diodes to limit RF voltage on PA input at 15V level. Max input power level may be set by trimmer R17. Max output power level may be set by R22.The item "HF power amplifier KIT MOSFET VRF2933 LPF 300W 1.8-30MHz with control and LCD" is in sale since Tuesday, September 20, 2016. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers".
The seller is "r3kbo_4" and is located in Voronezh, default. This item can be shipped worldwide.ruOutput Power: 300W