ICOM IC-PW2 HF/50 MHz all-band 1 kW linear amplifier AC90~132V negative ground

  

All my products are 100% Authentic. Frequency Range 1.9, 3.5, 3.8, 7, 10, 14, 18, 21, 24, 28, 50 MHz, 4630 kHz. Output Power: 1 kW (when using 200 VAC system), 500 W (when using 100 VAC system). Excitation Power 100 W Max. Supply voltage: 90132 VAC (single phase 50/60Hz) 180264 VAC (single phase 50/60Hz). Unnecessary Radiation Intensity HF band: -60dB or less 50 MHz band: -70dB or less. Output matching impedance 16.7150? (HF to 50 MHz band, 4630 kHz). Antenna Tuner Matching Accuracy VSWR1:1.5 or Less. Operating temperature range -10°C to +40°C. External Dimensions 425 (W) x 149 (H) x 445 (D) mm (Excluding Protrusions). One multi-band BPF for SO2R. In the case of conventional linear amplifiers, two multi-band BPFs were required in order to prevent reception sensitivity from being suppressed by the transmitting waves of the own station when operating SO2R. However, the IC-PW2 automatically connects the multi-band BPF to the receiving transceiver when the transceiver to be transmitted is selected, enabling SO2R operation with a single multi-band BPF. Depending on the performance/specifications of the BPF and exciter, antenna installation conditions, etc. The performance may not be sufficient. In this case, please take measures such as using two sets of BPFs. Equipped with an RX-ANT connector that enables connection of receiving BPF, etc. The RX-ANT connector allows you to connect a band-pass filter, preamplifier, and attenuator. In SO2R operation, a multi-band BPF can be connected here. In addition, band switching of the multi-band BPF can be controlled from the band signal output terminal. There are two band signal output jacks, each of which can be set to INPUT1, INPUT2, send, or receive. It can be used not only for multi-band BPF but also for band switching of various external devices. This enables high-speed matching of approximately 2 to 3 seconds when re-tuning. We have also succeeded in significantly suppressing the emission of unnecessary radio waves during tuning. The antenna tuner operates even when the amplifier is off. Uses a separate controller equipped with a color liquid crystal display that supports touch operation. The controller can be set up to 3 meters (using the included cable) away from the unit. In addition, the large 4.3 inch color LCD supports touch operation. Combined with the graphical display, the antenna selection and various settings are intuitive. Uses a cooling system with high efficiency and quiet design. A multi-pronged protection circuit that prevents breakage or failure of each part. Equipped with an SD card slot. Support for farm up and configuration saving.

Equipped with a remote AUX jack that can be used to control element telescopic antennas. Antenna quick select function that allows you to set the antenna to be preferentially connected with one action. International Buyers - Please Note. I do not mark merchandise values below value or mark items as "gifts" - US and International government regulations prohibit such behavior. For Buyers Outside the U.