LPF HF +50MHz for HERMES Odyssey HiQSDR WSPR Raspberry Pi 20W, Low Pass Filter
This is a 7th order Chebyshev Low Pass Filter for using after HF power amplifier for removing harmonic. This LPF intended for HF amateur bands - 1.8 MHz, 3.5 MHz, 7.0 Mhz, 10 MHz, 14 MHz, 18 MHz, 21 MHz, 24 MHz, 28 MHz and 50MHz. 3dB cut off frequency is 2.5 MHz, 5 MHz, 8.6 MHz, 15.5 MHz, 25 MHz, 35 MHz and 55 MHz.You can choose cut off frequency by setting up binary code with 3.3v or 5v logic levels, see pictures above. All bands insertion loss is less than 0.5 dB. You can see attached graths for exact, per bands, values. Input and output impedance is 50 Ohm. Input and output connectors is SMA female. LPF Return Loss is better than 35 dB for any band. Maximum handled power for any band is 20w. Ontinuously, 40w with 30% duty. Only high quality and original components using - AMIDON T50 cores, TAKAMISAWA relays, and NP0 Hi-Q. Temperature should be under control. Board size is 120 x 75 mm. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Amplifiers". The seller is "60dbmco" and is located in this country: UA.
This item can be shipped to United States, all countries in Europe, all countries in continental Asia, Canada, Australia.
- Number of Channels: 1
- Model: 20WHF+50-LPF
- Country/Region of Manufacture: Ukraine
- Band: HF, RF
- Type: Low Pass Filter
- Supported Modes: AM, CW, FM, QRP, SSB
- Number of Outputs: 2
- Frequency Band(s): HF
- Max. Output Power: 20W
- Number of Inputs: 1
- Power: 20 W
- Brand: 60dbm.