NanoVNA-F 1.5GHZ VNA HF VHF UHF Vector Network Antenna Analyzer + 4.3 LCD + Case

  

The RF part is consistent with the original version (NanoVNA-F uses harmonic spread measurementfrequency to 1 GHz). NanoVNA-F hardware functions include and are not limited to the following improvements. Use 4.3-inch IPS TFT LCD screen, with a larger view angle and can be seen clearly in strong outdoor light. Switch to large capacity 5000mAh lithium battery, standby time is longer, and expand a USB interface.

Switch to a power switch with a greater sense of operation and a better sense of operation. Support Chinese and English menu switching. Upgrade the user program by virtual U disk. Standard aluminium shell to protect SMA head and reduce the interference of external electromagnetic wave to instrument.

The hardware block diagram of NanoVNA-F is as follows. NanoVNA-F measurement range is 50k-1GHz.

The harmonic spread measurement frequency of the output signal of the clock chip SI5351 is 1000MHz. At 600M-1GHz, the dynamic range of S11 is 40dB (standing wave ratio is less than 1.02). At the same time, a metal shield is designed for the RF front-end, so that the dynamic range of S21 is better than 60dB in the whole frequency band. Dimensions: 14CM 7.5CM 2CM (length, width and height). RF output: - 13 DBM (maximum - 9 dbm). Display: 4.3 inch IPS TFT (800x480). USB Interface: USB Type-C Communication Mode: CDC (Serial). Power consumption: USB 5V 200mA, built-in 5000mAh battery, theoretical life of 18 hours, maximum charging current 2A. Output capability: 5V/1A, supporting Android and Apple phones. Number of calibration points: 101. Designing a metal shield for the RF front end, allowing the S21 to have a dynamic range better than 60dB over the full frequency range. Supporting Android and Apple Mobile. NanoVNA-F S11 parameter, SWR standing wave ratio test. UV9D antenna U-band standing wave ratio measurement, starting frequency: 300M, termination frequency: 600M, standing wave minimum frequency 441.000000MHz, SWR = 1.03. S21 insertion loss measurement, low pass, high pass, band pass filter measurement. Measuring 6.5M Ceramic Notch with NanoVNA-F. Measuring 10.7M ceramic filter using NanoVNA-F. A self-made low-pass filter was measured using the NanoVNA-F with a 3dB bandwidth of approximately 400MHz. Performance comparison, E5071C four-port vector network vs NanoVNA-F.

SMA-JJ RG316 cable 20CM x2 (NanoVNA-F is a standard SMA female connector, which is used to switch to M head and N head to better protect SMA female). 1 set of calibration parts 50? Standard load x1, open circuit calibration piece x1, short circuit calibration piece x1, use the included calibration piece, the instrument can be calibrated to get good measurement result data. SMA elbow external screw inner hole to inner screw inner needle x1. This item is in the category "Mobile Phones & Communication\Radio Communication Equipment\Ham/Amateur Radio\Ham Radio Amplifiers".

The seller is "2012moon816" and is located in this country: CN. This item can be shipped worldwide.