Powerwerx SS-30DV Switching Power Supply
Fluke meter is not included. This is a used piece of equipment. Which means it has been tested and working. If the item was not working it would be marked for Parts or Repair.
I have my items packed and sealed when they are listed. That means that they have been weighted and ready to go out. The information listed below was found online and does not reflect what is included in the sale. It is for reference use. The Powerwerx Switching Power Supply Model SS-30DV is designed to supply 25 Amps continuous and 30 Amps surge (up to 5 minutes) at 14.1 VDC.
Loads can be connected to either the rear binding posts or the front Powerpole connectors. Any output may provide up to 30 Amps individually, and the total output is limited at 30 Amps. Front Connection: 2 sets of Powerpole connectors. Rear Connection: 1/4 inch binding posts that also accept banana plugs, 1/4 inch ring terminals or compression connections.
Input Range: 100-120 VAC or 200-240 VAC, 50/60Hz (Switchable). Output Voltage: 14.1 VDC fixed. Output Amperage: 25 continuous, 30 surge.
Internal Protection: Thermal, over current. Internal Input Fuse: 6.3 Amps at 115 VAC. Storage temperature: -20 - 85 °C. Overall Dimensions: 6.1 x 5 x 2.5 in (154mm long, 127mm wide, 63mm tall). Fan: Quiet internal cooling fan. Machined metal case front bezel. Meets FCC CFR Title 47 Part 15 Subpart B: Class B, CISPR: 2005 ANSI C63.4: 2003. Meets CE/LVD (Low-Voltage Directive 2006/95/EC) standard. Meets EMC: EN 55022:206+A1: 2007, 2010, EN 61000-3-2:2006. The Powerpole connectors mounted on the front panel conform to the RACES/ARES standard orientation. For 115V AC applications, set the recessed 115/230 input select switch located on the rear of the power supply into the proper position. Positions are identified on the switch.
Use a small screwdriver to slide the switch into position. No adjustment is necessary for either 50 or 60 Hz input. Land mobile radio base stations. AC Power Cord, 4 ft.
Unplug the power supply from the mains supply outlet. Select the correct input voltage (See Input Voltage Selection).Connect the power cable's positive (red) wire to the positive terminal and connect the negative (black) wire to the negative terminal on the back of the power supply or use the Powerpole connectors mounted on the front panel. Plug the power cable into the power socket on the back of the radio. Plug the power supply into the mains supply outlet. Turning the power supply on.
Turn the power supply on by pressing the power switch to the'ON' Position. Turning the power supply off. Before you turn the power supply off, turn the radio off as described in the user documentation for the radio. Then turn the power supply off by pressing the power switch to the'OFF' Position. The SS-30DV power supply is cooled by convection and forced air cooling (normal airflow around the power supply in combination with a temperature controlled fan to improve cooling at higher levels of use).
The fan is activated by a sensor when the temperature rises above 70°C. The Powerwerx support policy is simple: we want you to be happy! We reserve the right to upgrade your equipment to an equivalent or better model.
