TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used    TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used

TOKYO HY-POWER HL-130U 430MHz RF Power Amplifier. C : Very Good -A few scratches but looks good. This is a working HL-130U, an all-mode linear amplifier for the 430MHz band from Tokyo High Power. Receive amplifier gain: 12.7dB at 433.00MHz. Transmit amplifier: 130W or more at HIGH and 70W or more at LOW when 10W input. Measurements of input/output power and current consumption are attached. Other forced standby and SSB/FM switching are working normally. The first stage attenuator is always on, and the next stage attenuator is set to turn on at an input of about 13W. As you can see from the 8th photo, I think it is best to operate with an input of up to 11W.

Red and black 0.8m power cable with terminals (3.5SQx2) 1 set. Wave-illuminated switch (green) 2 pieces. N-type connector (input/output) 2 pieces. Relay (changed to sealed type) 3 pieces.

Rear connector board, bottom cover re-plating 1 set. Full sterilization cleaning of outer casing, connectors, etc. Green: Transmits when set to GND. Yellow: Transmits when +13.8V (+12V is also possible). There is no return line, but a return is formed by connecting the radio to a coaxial cable, allowing you to switch between transmit and receive. It will also work with a carry-con, but it will significantly shorten the life of the coaxial relay. The HL-130U has an internal attenuator that switches according to the input level. So it can operate over a wide range of input levels. It is in excellent condition with few scratches overall.
The bottom plate and back panel have been re-plated. The entire surface has been sterilized and cleaned, so there is no dirt. The power cable has an M6 crimp terminal (for the land end). S : New/Unused(Open box) A : Mint -Almost Unused B : Excellent - Beautiful item for used C : Very Good -A few scratches but looks good D : Good -Just fine E : Imperfect -There may be a problem or shows sign of age F : For parts or not working, untested, only powered on, needed maintenance, etc..
The EMS is the safest and quickest way of Japan Post. Due to the influence of virus. Our products are 100% Authentic. We are really glad to have a deal with people all over the world.
International Buyers - Please Note.
TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used    TOKYO HY-POWER HL-130U 430MHz Power Amplifier Used